Performance:
     ●  Design Pressure = +80/ -80 PSF
     ●  Air Infiltration at 6.24 P.S.F. < .06 CFM
     ●  Water @ 20 PSF

Features Include:
● Glazing gaskets:
     ●  Same EPDM dense gasket used on interior and exterior at glass
● Screw spline joinery allows:
     ●  Coral Punch Die shop fabrication
     ●  Die set punches spline and pressure bar weep holes
     ●  Panelized frame assembly for easy transporting and installation
● Pressure Bars:
     ●  Preloaded with a dense EPDM thermal isolator at factory with attachment holes pre-  punched 9" O.C.
     ●  Attached to back members with #12-14 x 1 ¼" HWH #3 self-drilling   screws
● Removable snap-on interior trim covers at all horizontals allows:
     ●  Anchor inspection to substrate after glazing
     ●  Inspection and/or repair of critical joint seal areas after glazing
● Injection molded plastic end dams and bridges at horizontals provides:
     ●  Accurate and tight seals at intersection of vertical/horizontal joints
● Zone glazed system with weep holes for water control
● Weep holes
● Injection molded plastic top and bottom vertical mullion caps:
     ●  Accurate compression fit
     ●  Provides continuous perimeter seal
● Injection molded plastic temporary glazing retainer:
     ●  Reduces labor
     ●  Distributes uniform pressure on glass reducing risk of breaking glass
     ●  Reusable for next project

Florida Product Approval: FL12880